Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Line Out
Line output RCA L/R connectors can be used to connect (daisy chain) multiple OCT-
BSAR200 amplifiers together. The number of amplifiers should be limited to 4 in this type of
configuration.
2.
Line In
Line input RCA L/R connectors for connection to your source device.
3.
Auto Switch
Auto position enables the amplifier to turn of from standby mode when input signal is
detected. The ON position will keep the amplifier in a continuous powered on mode.
4.
Stereo / Bridge Switch
The OCT-BSAR200 amplifier can be used in stereo and bridge modes. In stereo mode L/R
channels are separated, when used in bridge mode the L/R channels are combined as mono
output.
5.
Speaker Out
Speaker outputs are for stereo or bridge mode. The connectors are binding posts style and
will accept banana type connectors or bare wire.
6.
Voltage Switch
This amplifier can accept 110V to a 240V for either North American or European use. Make
sure the amplifier is powered off and the cord unplugged before changing the voltage.
7.
Fused Power Input
Connect included power cable to power input connector, then to power source. Below the
power cable input is the fuse assembly. Disconnect power to amplifier before removing fuse
assembly, pull straight out to access the main and spare fuse.
WARNING: Do not plug amplifier into any type of power conditioner.
8.
Pair
Press the pair button on the receiver unit. When the Wave-Link Transmitter has a steady blue
light, it is paired.
4
AMPLIFIER OPERATION – REAR PANEL
Publicidad
