Publicidad
La información sobre la identificación del
registrador de datos también se puede encontrar en
el manual de instrucciones del registrador de datos.
La caja Com del tipo VKPC 40plus Ex lleva la
siguiente identificación:
VKPC 40plus Ex
II 2G Ex ib IIC T4 Gb
BVS 15 ATEX E002
Ex ib IIC T4 Gb
IECEx BVS 18.0048
A la caja Com del tipo VKPC 40plus Ex solo se
pueden conectar sensores de valores medidos del
tipo VKPS 40 Ex con la etiqueta Ex ib IIC T4 Gb.
La conexión y desconexión de los componentes
solo debe llevarse a cabo fuera de la atmósfera
potencialmente explosiva.
El sensor de valores medidos del tipo VKPS 40 Ex
lleva la siguiente identificación:
VKPS 40Ex
Ex ib IIC T4 Gb
Información adicional para su uso en Estados
Unidos y Canadá
Classification for hazardous locations:
Class I Zone 1 AEx ib IIC Gb T4
Class I, Division 2 Groups A-D, T4
This device contains:
FCC ID: T9J-RN42
IC: 6514A-RN42
This device complies with Part 15 of the FCC Rules
and with Industry Canada license exempt RSS
standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils radio
exempts de licence.
L'exploitation est autorisée aux deux conditions
suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le
fonctionnement.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy, and if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to radio
or Television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV
technician for help.
11
Publicidad
