Adjusting The Receiver; Scan Function; Lock Function - Monacor International JTS IN-164R /5 Manual De Instrucciones

Receptor uhf diversity
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5.1 Adjusting the receiver

When the receiver is not locked, press the button
SET (6) to activate the setting modes one after
another:
group (keep button pressed for a while)  channel
 scan function  identification number  lock
function
To make settings in a setting mode, see the corre-
sponding chapter (5 1 1 to 5 1 4)
To exit a setting mode without changing a setting,
press the button SET repeatedly until the display
briefly shows
then return to the normal mode
5.1.1 Transmission frequency (group /channel)
To set the transmission frequency, select the chan-
nel group and the channel Six channel groups with
preset channels in different numbers are available
table on page 24
Note: To prevent interference, carefully match the trans-
mission frequencies of all transmission paths at the place
of application to one another In case of parallel operation
of several channels, it is recommended to use channels
from the same group
1) Keep the button SET (6) pressed until the letter
"G" starts flashing on the display; the group
setting mode is activated
2) Select the group (
(5) or the button
3) Press the button SET to confirm The letters
"CH" start flashing on the display; the channel
setting mode is activated
4) Select the channel with the button
When the scan function has been activated
(
chapter 5 1 2), each time a channel is se-
lected, the unit will check if the corresponding
transmission frequency is presently being used
for transmission (brief insertion
channel") If it is, this channel already used will
be skipped
5) Press the button SET to confirm The display
briefly shows
return to the normal mode
12
(= cancel) The receiver will
) with the button
(7)
(= store) The receiver will

5.1.2 Scan function

The scan function makes it easier to select a free
transmission frequency: When the function has
been activated, the frequencies already being used
for transmission will be skipped when you set the
transmission frequency (
1) Keep the button SET (6) pressed until the letter
"G" starts flashing on the display; the group
setting mode is activated
2) Press the button SET repeatedly until the display
shows the current setting for the scan function:
3) Press the button
or the button
4) Press the button SET to confirm The display
briefly shows
the normal mode
5.1.3 Identification number
To set the transmitter to the transmission fre-
quency of the receiver via the REMOSET function
(
chapter 5 2), both must have the same iden-
tification number
1) Keep the button SET (6) pressed until the letter
"G" starts flashing on the display; the group
setting mode is activated
2) Press the button SET repeatedly until the display
shows
( ...
3) Select the desired number with the button
or the button
or
4) Press the button SET to confirm The display
briefly shows
the normal mode
5) Then set the identification number on the trans-
= "scan
mitter

5.1.4 Lock function

When the lock function has been activated, the
REMOSET function will not be available (
ter 5 2) and it will not be possible to switch off the
receiver From the setting modes, you will only be
able to activate the mode for the lock function in
order to deactivate the lock
chapter 5 1 1)
scan function activated
scan function deactivated
(5) to select the setting
(7) to select the setting
The receiver will return to
and the current identification number
)
(7)
The receiver will return to
instruction manual of the transmitter
(5)
chap-

Publicidad

Tabla de contenido
loading

Tabla de contenido