Descargar Imprimir esta página

GreenWorks G24JACK Manual Del Operador página 9

Gato hidráulico
Ocultar thumbs Ver también para G24JACK:

Publicidad

Idiomas disponibles

Idiomas disponibles

2. Press power switch (1) to the ON position.
Note: With the battery installed and the power
switch ON, the white LED light (2) and the hazard
lights (3) will automatically turn on until the power
switch is turned OFF or the battery loses charge.
5.2
TURN THE LIGHTS OFF
1
1. Press power switch (1) to the OFF position to turn
the lights off.
2. Remove the battery pack.
5.3
OPERATE THE PRODUCT
WARNING
Never work under the vehicle while raising,
lowering, or using the jack. Always use
appropriate jack stands after vehicle has been
raised.
When using the jack, make sure the vehicle engine
is turned OFF, all passengers are out of the
vehicle, and all doors are shut.
This jack cannot be used to support bumpers,
beams, and other parts.
This product should be operated by adults only.
1. Park vehicle on a firm, level surface.
2. Place the vehicle in park and apply the parking
brake. Turn the engine off.
3. Place wheel chocks as necessary.
4. Install the battery pack.
5. Place the jack under the vehicle. Please refer to
the vehicle owner's manual for correct placement of
jack.
English (Original Instructions)
1
6. Rotate the saddle (1) counterclockwise to decrease
distance between jack and vehicle, or rotate the
saddle clockwise to increase distance between the
jack and the vehicle.
7. Turn the power switch to the ON position.
8. Press and hold the directional switch in the up
position (2) to raise the jack. Release switch once
the jack has reached the desired height, and install
jack stands per separate jack stand instructions.
9. To lower the jack, press and hold the directional
switch in the down position (3). Once the jack is
completely retracted, remove from vehicle.
10. Turn the power switch to the OFF position.
5.4
USE THE RELEASE VALVE
In the event of the jack loses power and the piston is not
able to be retracted, please follow the steps below:
Note: The steps below are only intended for when the
battery has lost power. They are not intended for normal
operation.
9
EN
2
3

Publicidad

loading