JANE Baby Side Instrucciones De Uso página 17

4) Bring the mini cot closer to the parents' bed and adjust the height so that the mattress of the adult bed is above
the top edge of the open window.
To attach the co-sleeping mini cot to the adult bed, used the two additional straps provided with the mini cot.
* Note: In co-sleeping mode the same height must always be selected for both legs.
5) Fasten the black clasp of the additional strap to the clasp found on the lower part of the frame under the cover.
The red clasps on the strap should be facing upwards.
6) Pass the free end of the strap underneath the structure of the adult bed (A) and wrap it round to fasten the free
end of the red clasp with the red clasp positioned closest to the BABYSIDE mini cot.
A
DIVAN BEDS:
hand to insert the leg to adjust it to the new length.
Press the unlocking point, conceal the leg and bring it into contact with the side of the bed until the mattress of the
mini cot is touching the adult mattress.
Tighten the 2 fastening straps securely.
7) If the legs of the co-sleeping cot go underneath the adult bed, proceed as before and bring the mini cot closer
until the mattress in the cot touches the mattress on the adult bed.
Tightening the 2 fastening straps securely.
WARNINGS:
-Check that the co-sleeping mini cot is securely attached to the adult bed, do this by pulling the mini cot away from
the adult bed.
fastening system provided.
NOTE:
-There should never be any free space between the side bar of the window and the adult mattress.
-If there is any free space between the co-sleeping mini cot and the adult bed DO NOT use the product.
mini cot' section.
A
CLICK
*
2
1
"SLIDE"
2
"PRESS"
1
OK
MATTRESS
5
17 17
"click"
1
2
"PRESS"
STOP
NO
MATTRESS
5
2
1
3
4