Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Operating instructions
Maintenance and Cleaning
The machine requires little maintenance. It is only necessary to ensure that lubrication is
provided via the compressed air.
Before the first use of every pneumatic tool, the motor should be lightly oiled. For this purpose,
place few drops of oil directly into the air inlet (4), also when the air supply is equipped with a
maintenance unit. See details below.
Should the machine malfunction in spite of careful manufacturing and testing procedures, have
the repairs performed by an authorised customer service location for MBX
For all correspondence and spare parts orders, always include the serial number on the type
plate of the machine.
Specifications of the oil to be used.
Viscosity at 40°C:
Specific Weight at 15°C:
Flashpoint:
TG:
Lubrication of the motor:
1. Separate the tool from the compressed air in order to avoid activation.
2. Only use oil as per the specifications above
3. Clean the air inlet before oiling
4. Insert the oil (approximately 2–3 drops), keep the trigger pressed during oiling to ensure the
oil passes through the valve to reach the rotor.
5. After oiling allow the machine to idle at the lowest power setting. Do not speed up
immediately as oil needs time for wetting the rotating parts.
Environmental Protection
Recycle raw materials instead of disposing as waste
The machine, accessories and packaging should be sorted for environmental-friendly recycling.
The plastic components are labelled for categorized recycling.
Warranty
For MBX
Pneumatic, we provide a warranty in accordance with our conditions for sale and
®
delivery. Damage caused by normal wear, overloading or improper handling is excluded from
the warranty.
8
32 to 68mm²/s 32 to 68
0,877 g/cm³
>210°C
-32°C
MBX
PNEUMATIC
®
Pneumatic tools.
®
Publicidad
