WARNINGS
The purpose of these operating instructions is to familiarise you with the operation of
this product. Therefore, keep these instructions in a safe place so that you can refer to
them at any time.
•
Do not start installation until you have read and understood the complete operating
instructions.
•
Remove the product from its packaging and remove all packaging materials. Make
sure that there is no packaging material on or in the product. If you notice any
damage to the packaging, also check whether there is any damage to the
product. If you notice any external damage to the unit or any unexpected or unusual
functioning, do not continue to use the product. Contact the dealer from whom
you purchased the product or celexon directly (Web: www.celexon.co.uk, Mail:
info@celexon.co.uk) for further information.
•
To ensure trouble-free operation, the product must only be used indoors, it is NOT
suitable for outdoor use.
•
The use of the product and accessories is prohibited for children under 16 years of
age.
•
Ensure that children do not play with the appliance or stay in the vicinity without
supervision.
•
Caution: Risk of injury! Never open the product without authorisation. Never carry
out repairs yourself!
•
Do not use the product in the vicinity of escaping gas, water or in a dusty
environment.
•
Handle the product with care. It can be damaged by knocks, blows or falling from a
•
from even a small height.
•
Keep the product away from moisture and heat.
•
Never immerse the product in water or other liquids.
•
Only use the product in its intended manner. Any other use may result in damage to
the product or its surroundings.
•
Use this product only on a stable surface to prevent it from falling over and causing
damage to the product or injury.
•
Carefully connect the cables to the connectors and also carefully disconnect them
after use.
•
Make sure that the connected cables are protected from jerky movements.
•
Do not touch the camera lens!
•
All supply lines and cables must not be subjected to additional loads and must be
1