Publicidad
Idiomas disponibles
Idiomas disponibles
4.2
TANK FILTER
4.2.1 Installation
If the water hardness is more than 5°f,
the use of a BRITA filter (supplied) should be
installed in the tank. Not only does this filter
reduce limescale build-up, but it also eliminates
any impurities and other substances such as
chlorine in the water.
Install the filter in the tank according to the
manufacturer's instructions.
4.2.2 Water liter count and filter replacement
The machine is equipped with an automatic system for measuring the water used in order to indicate when it is necessary to
replace the filter of the tank. And in particular
the low-frequency flashing of the HOT WATER button LED
the high-frequency flashing of the HOT WATER button LED
The LED flashing (about 10 seconds) takes place after every brewing (coffee, hot water) and turning on the machine. The
flashing of the LED does not preclude any functionality of the machine.
To stop the LED flashing after replacing the filter, turn on the machine while holding down the left
Manual dispensing button for 3 seconds.
Replace the filter at the bottom of the tank according to the manufacturer's instructions.
4.3
ELECTRIC POWER SUPPLY
The connection of the machine to the electrical mains must be carried out by qualified personnel only.
espresso coffee machine - user instructions
shows that the filter should be replaced after 15 more liters
shows that the filter should be replaced
E S P R E S S O
P O I N T
or right
english
67
Publicidad
