Publicidad
Idiomas disponibles
Idiomas disponibles
Model - Modello - Modèle
Modell - Modelo - Modelo
Constructeur - Fabbricante
Manufacturer - Hersteller
Fabricante - Fabricante
16. EQUIPMENT IDENTIFICATION
•
Located on the plate affixed to the machine to detect the technical data.
•
Check the model and power supply voltage before carrying out any operation.
•
If discrepancies are found, immediately contact the manufacturer or the company that supplied the equipment.
It is strictly forbidden to remove, tamper with the plate and change or alter the data
contained in it.
17. POSITIONING
The appliance is equipped with adjustable feet.
To secure and position the appliance, screw or unscrew the feet.
It is strictly necessary after positioning to stabilise the equipment on the ground.
18. MAINTENANCE
WARNING! Maintenance must be carried out by technical staff trained and enabled for intervention
on the flammable refrigerants.
WARNING! Any work carried out on the appliance by the user strictly requires the power plug being
disconnected from the mains socket.
ATTENTION! Use protective shoes and gloves during maintenance operations.
OPERATION
Cleaning of external surfaces
Cleaning of accessible internal parts (no use of tools)
Seals intactness check
Water collection tank cleaning
Checking and cleaning the condenser if necessary
Replacement components and parts
* Recommended frequency for optimal counter operation and maintenance of full efficiency.
Any other maintenance operation not planned in the previous points should be carried out by the
support centres authorised by our dealers or by qualified staff.
19. PUTTING INTO OPERATION
If the cabinet has been sharply tilted while being sited or for mounting of accessories, it must be left to stand for
at least three hours before being started to allow the lubricating oil to settle in the compressor.
Failure to do so can cause total destruction of the compressor refrigerating system.
Check that the voltage on the identification plate is the same as that of the network.
THE ELECTRICAL SUPPLY LINE TO WHICH THE REFRIGERATOR WILL HAVE TO
BE CONNECTED IS TO BE PROTECTED BY A VERY SENSITIVE DIFFERENTIAL
SWITCH (Rc=16A,Dc=30mA); IT IS ALSO TO BE LINKED TO THE
GENERAL EARTHING PLANT.
Earthing is necessary and compulsory by law.
Absolutely never use reduction units, patch cords, adapters or multiple socket
outlets to connect the counter. DIRECTLY connect the equipment to the mains.
The cable should be fully extended and located where it is unilikely to be struck, caught or stepped on,
away from water and the other liquids and heat sources and must not be damaged. In case of breakage of the power
cable of the cabinet, it must be replaced by the manufacturer or by instruction it change of it.
Follow the manufacturer's instructions to install the unit, using qualified personnel and complying with the electrical
regulations for the specific country. Incorrect installation may cause injury and damage; the manufacturer is not liable
The manufacturer disclaims all responsability for any damage to people or things
for this.
due to incorrect observance of this rule.
FIZZ 42
BITTER 42
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
FREQUENCY
Based on use
Based on use
MAINTENANCE
Ordinary
Ordinary
Yearly *
Ordinary
Yearly *
Ordinary
Yearly *
Ordinary
-
Extraordinary
1 7 / 6 0
PAGE
N° DOC
AUTHORISED STAFF
User
User
Technical support
Technical support
Technical support
Technical support
Publicidad
