Duronic WM32 Manual De Instrucciones página 8

FIRST USE
Unpack your WM32 Snack Maker and set the packaging aside. Open the lid,
clean the cooking surfaces thoroughly by wiping them with a damp sponge
and dry the surfaces with a paper towel.
HOW TO MAKE WAFFLES
Put the waffle hotplates into the snack maker.
Plug the power cable into a mains outlet and allow the snack maker to preheat
while you make the batter.
The red indicator light will illuminate when the plug is connected to the mains
outlet; it will stay on continually until the appliance is switched off. The green
light will also illuminate straight away and it will go off when the appliance has
heated up to the optimal temperature. It will take around 3 minutes to heat up,
then the green light will turn off to indicate that the Snack Maker is ready for
use.
1. Carefully pour the waffle batter into the hotplate. Fill up the plate
close to the rim, leaving a little bit of space. Close the lid gently.
The hotplates are non-stick so you do not normally need to add anything
to grease the plates. However, if you find your waffle batter sticks to the
plates too much, you may need to wipe a very small amount of melted
butter or oil with a pastry brush onto the hotplates.
2. Cook for 6-8 minutes until the waffle come away from the top plate
easily.
CAUTION: The appliance is not to be operated in the open position.
Always close the lid during cooking.
3. Remove the waffle from the hotplates with a plastic or wooden
spatula. Be careful with your waffle, as they will be quite hot. Allow
to cool for a few minutes before enjoying.
If you wish to continue making waffles, the next one will cook more
quickly as the hotplates will already be hot.
How to Use
8