Korenix JetNet 5628G Guía De Instalación Rápida página 5

Note 1: We recommend using Korenix certificated SFP mini GBIC transceiver.
Note 2: Cross-connect the transmit channel at each end to the receive channel at the
opposite end as illustrated in the figure below.
SC Connector
RX RX
TX TX
Cable Wiring(SC to SC)
Warning: The Fiber interface is Class 1 Laser/LED product. Do not stare at the
Laser/LED beam.
Device Management
JetNet 5628G Rack Mount Managed Ethernet Switch provides both in-band and out-band
configuration methods. You can configure the switch via the RS232 console with the attached
console cable. Or you can remotely manage the switch via network. You can choose
Telnet/SSH, Web/HTTPS management.
1. Preparation for console management: Attach the RS-232 DB9 connector to your PC's COM
port. Connect the RJ-45 connector to the console port of the JetNet 5628G.
1.1 Go to Start -> Program -> Accessories -> Communication -> Hyper Terminal
1.2 Give a name to the new console connection.
1.3 Choose the COM name, and select the correct serial settings. The serial settings of the
JetNet 5628G are as below: Baud Rate: 9600 / Parity: None / Data Bit: 8 / Stop Bit: 1
1.4 After connected, you can see Switch login request. Type the username and password
then you can login. The default username is "admin", password is "admin".
1.5 Follow the manual to configure the software features.
2. Preparation for Web management: Before you attempt to use the embedded web interface
to manage switch operation, verify that your JetNet 5628G is properly installed on your network
and that every PC on this network can access the switch via the web browser.
SFP Connector (100Base-FX/1000Base-x)
TX TX
RX RX
A B
Cable Wiring (LC to LC)