MSW Motor Technics MSW-CCW30 Manual De Instrucciones página 27

• Make sure that the mode switch is in the off ("OFF" or "O")
position before connecting the power cord in question to the
corresponding outlet.
• Then connect the given power cable first to the appropriate
socket on the device (in the MSW-CCW24-A model, the 12V DC
cable is permanently connected), and then to the appropriate
external power socket.
• ATTENTION: some vehicles have a 12V socket permanently
connected to the (starting) battery, so do not leave a working
device connected to the car socket when the engine is turned off
- the risk of battery depletion! Also, unplug the device from the
12V socket before starting the vehicle engine - otherwise the
voltage drop during startup risks damaging the device!
3.3.2 Operation mode selection and use
• Use the mode switch to select whether you want to keep the
products inside cooled ("COLD") or warm ("HOT") - the indicator
light will illuminate in the corresponding color, i.e. green =
cooling, red = heating.
• [only in MSW-CCW30 ] select the efficiency mode between
"MAX" and "ECO" with the switch. The "MAX" setting is useful
when there is a large difference in temperature outside
compared to the one you want in the device chamber. This
setting also allows the fastest cooling or heating of the appliance
chamber. If there is not much difference in temperature
between the one outside and the target temperature in the
device chamber, select the "ECO" position, which further saves
energy.
• IMPORTANT: it takes about 30 minutes for the device to reach
the temperature in the chamber 15
environment in which the device is located (min. 10
a similar time for the device to heat up the chamber to approx.
60
chamber already have the target temperature, especially this
applies to chilled products, which will allow the device to work
more efficiently. Otherwise, it can take the device up to several
hours to cool the products in question!
ATTENTION: the device is not designed to defrost or heat cold
food!
NOTE: changes between heating and cooling function should be
made with a 30-minute break with the device in the off state.
• Remove the lid, place the desired food products in the chamber,
and put the lid back on tightly.
C. It is recommended that the products placed in the
o
° C lower than the
C). It takes
o