ulsonix TOPCLEAN 750VPRO+ Manual De Instrucciones página 46

a) Turn the control handle upright and lay the machine down on the floor. Then
align the brush with the three-blade plate and turn the brush 30 °
counterclockwise. The assembly is complete.
b) If it is necessary to replace the brush, hold the brush and turn it 30 °
clockwise to remove the brush.
A - Plate with three blades
Installation of the dirty water tank
a) Unpack the machine and the dirty water tank.
b) Set the machine's control handle to the vertical position. Hook the dirty
water tank on the starting handle with the two protruding hooks.
c) Then connect the vacuum hose and suction hose to the connectors on the
cover of the dirty water tank.
Note
Connect the suction hose (left) to the connector on the left side, the vacuum hose
should connect to the right connector. Do not cross them to avoid damage to the
vacuum cleaner engine.