3. Make sure the booster is charged by
4. Connect the red clamp to the (+) of the
5. If the «Start» light is green and the
30''
30"
6. Starting the vehicle: The «Error» in-
START
7. Remove immediately the 2 clamps of
POWER SUPPLY
1.
Plug the optional switch cable to 15V/5A output port.
2.
Connect the optional switch cable and 12V vehicle products or 12V
electronics.
FLASHLIGHT FUNCTION
Press and hold the switch button 3 seconds to start the LED light.
There are 3 modes for LED light appear in order (constant, strobe, SOS)
if you press slightly.
www.fulbat.com
checking the number of indicators on
the device.
battery. Connect the black clamp to the
(-) of the battery.
«Error» light turns off, everything is
ok. The green light stays ON for 30 se-
conds so the user has 30 seconds to go
and start his vehicle. If no action is done
during this time, the booster cable turns
itself off and the «Start» and «Error»
indicators will flash again alternately.
Unplug and plug back your booster cable
to the connector device. If only the «Er-
ror» indicator is turned ON, starting the
vehicle is not possible.
dicator flashes red and an alarm beep
goes off.
the vehicle battery and unplug also the
booster cable from of the connector.
PROTECTIONS
This device has short circuit proof, overcharge and discharge protection
TROUBLESHOOTING
Troubleshooting
No response while
pressing the ON/OFF
button
"Error" light ON on
the booster cable
Polarity reversal
"Error" light flashes
red + alarm beep
Clamps have been
left connected to the
WEEE - Waste Electrical & Electronic Equipment
Do not dispose of Waste Electrical & Electro-
nic Equipment in with domestic rubbish.
4
Causes
Remedies
The booster is
Charge the product
discharged
Internal battery
Charge the product
voltage < 11.0V
Check that the clamps
are well connected
and unplug/plug back
the booster cable
Check that the clamps
are well connected
Short-circuit
and unplug/plug back
the booster
Remove the 2 clamps
from the car battery
in order to protect
battery
the device