Lionelo Timon Manual De Usuario página 9

6.
Tighten the belts and make sure the baby's belt has been attached to parents'
bed properly.
TRAP RISK
In order to avoid trap risk, the baby's bed must be secured properly and attached
to parents' bed as recommended. The product must be attached to parents' bed
in a way that excludes any gaps between the product and the mattress.
If this is impossible, do not use the product as a bedside sleeper.
WARNING! Before each use, check that there is no gap between parents' mattress
and the side wall of the baby's bed.
FALL RISK
The baby's bed is designed for children whose weight does not exceed 9 kg. Remember!
Always lift the side of the baby's bed when it is not attached to the parents' bed.
NOTE! If the child can sit, kneel or pull itself, it should not use the baby's bed anymore.
HOW TO DISASSEMBLE
1. Take the mattress out.
2. Set the height of the baby's bed to level II.
3. Press both buttons under the top frame of the baby's bed at a time (on both
sides) (fig. 15).
4. Upper components of the bed's frame will fold (fig. 16).
5. Fold in the bottom of the bed.
6. Fold up the basket by lifting it up.
7. Wrap the mattress around the internal part of the baby's bed (fig. 17).
8. Press the button by the base to fold lower components of the bed's frame (fig. 18).
9. Do the same on the other side.
CLEANING AND MAINTENANCE
The product should be washed by hand using a mild detergent. Do not iron, do
not tumble dry. Mattress: machine wash at 60°C.
The product has been tested and meets all the requirements of the following standards: EN
The pictures in this manual are for illustrative purposes only. Therefore, they may differ from the actual
1130:2019+AC:2020, EN 16890:2017+A1:2021
product.
‑ 9 ‑ EN