Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction
Thank you for purchasing Atlantic Color Changing Pond Lights. Atlantic's Pond Lights feature
high impact cases and silicone gaskets for dependability and longevity. Whether underwater
or in open air applications, Pond Lights impart a soothing, warming glow after the sun
goes down. Available in single light or triple light kits with included removable photo cell
and transformer.
Prior to Operation and Installation
Caution:
• DO NOT operate this product under any conditions other than those for which it is
specified. Failure to observe these precautions can lead to electrical shock, product failure,
or other problems.
• Follow all electrical codes when installing Atlantic Lighting.
• To reduce the risk of electrical shock, connect transformer to a 120 volt receptacle protected
by a ground fault circuit interrupter (GFCI).
• Always verify that the lens is tightly secured before submersing the fixture
• Quick-connect plugs are gasketed for outdoor use and must be fully tightened to prevent
water infiltration. Quick-connect plugs are not waterproof and should not be submersed.
• Always use dielectric grease on all connections and verify that the lens ring is tightly secured
before submersing the fixture.
• Never shorten or cut the cord on Atlantic Color Changing Lights. Cutting/shortening the cord
will damage the LED and void the warranty.
• The InfiColor Smart Module is weatherproof, but must be mounted above the ground on a
wall or post within reach of a properly grounded GFCI outlet. Do not submerse the
Control Module or expose it to heavy rainfall. Failure to do so will void the warranty.
• The InfiColor Smart Module can be connected to an existing 12 volt AC lighting system by
cutting and splicing the flat low voltage wire that supplies power to the Module.
Installation
Pond Lights offer two different mounting options for your convenience:
• Adjustable stand: for placement on rock ledges, under waterfalls or for
highlighting streambeds
• Nestled: without the stand amongst the pond stones
Proper light placement is important for every project. Whenever possible, lights should be
positioned facing away from the viewing area to minimize hot spots. When camouflaging the
light cord with rocks and gravel, always leave enough slack in the cord so that the fixture can
be raised above water level for servicing.
Color Changing Pond Lights
The Single Zone InfiColor Smart Module is weatherproof, but must be mounted above the
ground on a wall or post within reach of a properly grounded GFCI outlet. Do not submerse
the Control Module or expose it to heavy rainfall.
• Install the Smart Module in a well-ventilated area to ensure that the Module operates within
its specified working temperature.
• Verify that the Smart Module input voltage is 12 volt AC. We recommend that you use the
transformer provided with this unit.
• Use dielectric grease on all connections and ensure that all cable connections are secure.
• Do not connect the power before the cord connections are finished.
• Do not cut or alter any round cords. Cutting or damaging any round cord will void
the warranty.
2
Publicidad
