Publicidad
Idiomas disponibles
Idiomas disponibles
f)
g) After finishing work, set the slowest speed with the throttle lever
h) If the machine will not be used soon, the residual water can be
3.4.
Cleaning and maintenance
a)
Pull the mains plug and let the unit cool down completely before cleaning,
adjusting or replacing accessories and when the unit is not in use.
•
Wait until the rotating parts stop.
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
d)
Do not immerse the unit in water.
e)
Make sure that no water enters the engine through the air filter.
f)
The ventilation ducts should be cleaned with a brush and compressed air.
g)
Perform regular inspections of the unit checking technical fitness and any
damages.
h)
Use a soft cloth for cleaning.
i)
Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) for
cleaning as they may damage the surface of the appliance material.
j)
Cleaning the air filter (sponge):
•
Unscrew the air filter housing cover screw, remove the cover and
remove the filter.
NOTE: if the engine will not start when the unit is hot, use the
procedure for a cold engine.
Use the throttle lever to set the desired RPM, and thus the pump
speed:
and then press the ignition switch to turn off the machine.
IMPORTANT: in the event that the ignition switch does not turn
off the machine, you can turn off the unit as an emergency by
removing the ignition cable pipe from the spark plug.
disposed of by unscrewing the drain plug.
Publicidad
