Keba KeContact M20 Guía Rápida página 107

M20
The antenna has been installed.
Mounting the antenna on the control cabinet
To mount the antenna, proceed as follows:
1) Switch off devices connected to the KeContact M20 and disconnect their
2) Unscrew the locknut and remove it and the washer from the antenna.
3) Feed the antenna cable into the control cabinet through a predrilled hole
4) Pull the adhesive film off the antenna, align the antenna and press it on
5) Use the washer and locknut (included in the scope of delivery) to fasten
6) Tighten the antenna cable at the two antenna connections.
The antenna has been installed.
Brief instructions V1.01
© KEBA 2022
power cables.
(for M10 screw).
the outside of the control cabinet.
the antenna on the inside of the control cabinet (max. 5 Nm).
Connections and wiring
107