Aqua Medic aCone 1.5 EVO Manual De Instrucciones página 7

1. Product description
The aCone 1.5 EVO skimmer consists of the following parts:
- conical reaction pipe
- foam cup and lid
- adjustable venturi pump DC Runner 3.1 incl. Aqua Medic needle wheel
- an adjustable outlet
- silencer
- air hose for venturi pump
- discharge hose incl. valve for foam cup
Fig. 1: aCone 1.5 EVO
1. Reaction pipe
2. Foam cup
3. Lid for foam cup
4. Silencer
5. Hose connection of
silencer
6. Adjusting screw
7. Drain valve
8. Adjustment for air inflow
9. Outlet
Available spare parts: Please refer to www.aqua-medic.de.
Type Outlet
height
aCone 1.5 23 cm
EVO
2. Principle of operation
The skimmer with venturi pump has to be placed in a separate filter tank. The water is pumped to
the skimmer by the venturi pump. The pump draws water from the filter tank and mixes it with air.
Within the pump housing, the bubbles are cut into very fine pieces by the Aqua Medic 3D-needle
wheel. The air/water mixture is pumped back into the skimmer. The treated water flows through
the outlet or drain valve out of the skimmer back into the filter tank.
Total height Venturi pump
(lower edge)
53 cm DC Runner 3.1 incl.
3D-needle wheel
10. O-ring for outlet pipe
11. Outlet pipe
12. Bottom plate (unscrewable)
13. Pump connection
14. O-ring venturi pump pressure side
15. Venturi pump
16. O-ring venturi pump suction side
17. Air intake nozzle
18. O-ring of foam cup
19. Plug for foam cup's outlet
Power
consumption
21 watts
Capacity
up to
1,500 l
7