Troubleshooting - DSR PROBOOSTER DSR104 Manual Del Usuario

13. TROUBLESHOOTING

Booster
PROBLEM
The booster does not recharge. The AC outlet is dead.
The Booster has no power.
The battery in the booster won't
hold a charge.
Charger
PROBLEM
The POWER LED
does not light when
charger is properly
connected.
The battery is
correctly connected,
but the CHARGING
LED did not light
immediately.
The battery is
properly connected,
but the CHARGING
LED never lit.
The LED is lit and
the CHARGING
LED is flashing.
REASON
Poor electrical connection.
The booster is not connected
correctly.
The battery is bad.
The booster's battery is not
charged.
The internal fuse has blown.
The battery is bad (will not
accept a charge).
POSSIBLE CAUSE
AC outlet is dead.
Poor electrical connection.
If the START/STOP button is
not pressed, charging should
begin in ten minutes.
The battery voltage is low.
The battery voltage is still below
10V after 2 hours of charging.
(or)
In maintain mode, the output
current is more than 1.5A for
12 hours.
Desulfation was unsuccessful.
Check for open fuse or circuit
breaker supplying AC outlet.
Check power cord and extension
cord for a loose fitting plug.
No problem; this is normal.
Press the START/STOP button to
start charging.
The battery may be defective. Make
sure there are no loads on the battery.
If there are, remove them. If there are
none, have the battery checked or
replaced.
The battery may be defective. Have
battery checked or replaced.
• 9 •
SOLUTION
Check for open fuse or circuit
breaker supplying AC outlet.
Check power cord and extension
cord for a loose fitting plug.
Verify the connections from the
station's charging plug to the
vehicle's battery.
Replace the battery.
Check the battery charge
status by pressing the
Voltmeter button. Recharge the
battery.
Replace the fuse.
Replace the battery.
SOLUTION