Dc Input Mode In Parallel For Geminus Line; Connection To Communication And Monitoring Interface - Peimar MIRUS LINE Manual De Usuario

5.5 DC input mode in parallel for Geminus line

For the connection of only one DC line on Geminus line inverters, compatibly
with electrical features, it is recommended the configuration of 2 MPPTs in
parallel.
For this connection mode it is suggested to use Y-wires as in diagram. There are
no display settings available for parallel connection of strings.

5.6 Connection to communication and monitoring interface

The Mirus, Unicus and Geminus inverters are equipped with an RS-232 interface.
5 4
6
The RS-232 interface can be connected to the Wi-Fi module which can be used
for uploading the inverter data to the server in order to monitor the operating
and production status remotely. For further details, refer to the relevant guide
(attached to the device or downloadable from the website www.peimar.com).
3 2 1
7 8 9
1. DCD (Data Carrier Detect)
2. RxD (Received Data)
3. TxD (Transmitted Ready)
4. DTR (Data Terminal)
5. GND (Signal Ground)
6. DSR (Data Send Ready)
7. RTS (Request To Send)
8. CTS (Clear To Send)
9. RI (Ring Indicator)
83
EN