SNOWJOE sunjoe SPX2700-MAX Manual Del Operador página 12

Using the Feather Bristle Pressure
Washer Utility Brush
Sun Joe feather bristle pressure washer utility brush safely
®
cleans painted, topcoat, and delicate surfaces. Compatible
with all Sun Joe SPX series pressure washers.
®
1. If not already done, detach your spray wand from your
trigger gun (Fig. 20).
2. Take the utility brush and align the two tabs with the inside
of the trigger gun (Fig. 23).
Fig. 23
3. Once aligned, push the utility brush into the trigger gun,
twist counterclockwise to lock into place.
Using the Wheel + Rim Brush
Sun Joe Wheel + rim brush safely cleans wheels and rims.
®
Compatible with all Sun Joe
1. Disconnect the spray wand from the trigger gun by
pressing it in firmly and twisting clockwise until the
2 locking tabs of the lance can be removed from the slot
(Fig. 20).
2. Take the wheel + rim brush and align the two tabs with the
inside of the trigger gun (Fig. 24).
3. Once aligned, push the Wheel + rim brush into the trigger
gun, twist counterclockwise to lock into place.
Fig. 24
1
Press the shaft inside
2
Twist the shaft as shown
Locking tab
Utility brush
SPX series pressure washers.
®
Shutting down
1. Turn the switch to the OFF (0) position and unplug the
power cord from the outlet.
2. Turn off the water source.
3. Hold the trigger to release water pressure.
4. Disconnect the garden hose from the water inlet on
the unit.
5. Disconnect the high-pressure hose connection on the
trigger gun handle.
6. Release the trigger and engage the gun safety lock.
m
WARNING!
Turn off the water supply and squeeze the
trigger to depressurize the unit. Failure to do so could result in
personal injury due to discharge of high-pressure water.
Taking a break
If you are taking a break of five minutes or more between
cleaning tasks:
1. Engage the gun safety lock on the back.
2. Turn the switch to the OFF (0) position.
3. Unplug the power cord from the outlet.
Storage
m
CAUTION!
Always store your pressure washer in a
location where the temperature will not fall below 32ºF (0ºC).
The pump in this machine is susceptible to permanent damage
if it freezes. FREEZE DAMAGE IS NOT COVERED BY THE
WARRANTY.
• Store the pressure washer indoors in a dry, covered area
where it is not subject to adverse weather conditions.
• It is important to store this product in a frost-free area.
• Always empty water from the hoses, the pump, and the
foam cannon bottle (if using) before storing.
m
CAUTION!
The use of a pump protector is
recommended to prevent cold weather damage during storage
over the winter months.
Winterizing + long-term storage
If you must store your pressure washer in a location where
the temperature falls below 32ºF (0ºC), you can minimize the
chance of damage to your machine by utilizing the following
procedure:
• Disconnect all water connections.
• Turn on the pressure washer for a few seconds until the
remaining water in the pump exits. Turn off immediately.
• Do not allow the high-pressure hose to become kinked.
12