Pfannenberg DTI Green Serie Instrucciones De Servicio página 132
Ocultar thumbs
Ver también para DTI Green Serie:
- Instrucciones de servicio (456 páginas) ,
- Instrucciones de servicio (396 páginas)
Publicidad
Idiomas disponibles
Idiomas disponibles
ENG
6.4.1.1
Removing/assembling the unit cover
CAUTION
Danger of crushing when removing/assembling the unit cover
Hands and other body parts may be crushed when removing and reinserting the unit cover.
•
Do not place any body parts between the frame, springs and the unit cut-out.
•
Work carefully and wear cut-proof gloves.
Removing the unit cover
Fig. 25: Removing the unit cover
Operating Manual | Attachment and Installation Cooling Units | Multi Controller (MC) – 230 V | 086100120
Prerequisite
DANGER – Danger to life due to electric shock. Make sure that the
unit is voltage-free.
Wait for a discharge phase of 10 minutes for the electrical components.
The unit should only be opened afterwards.
Procedure
1.
Remove the four screws (1) of the unit cover (2).
2.
Tip the unit cover forward by 20°.
ATTENTION – Damage to the unit.
Always pull off the earthing cable (3) from the inside of the unit
cover before removing the unit cover.
3.
Lift the unit cover (2) about 15 mm and pull the lugs (4) out of the
slits (5) in the floor plate.
The unit cover is removed.
G00017-01
58/74
Publicidad
