Garland CEPA 130 SBW-V21 Manual De Instrucciones página 28

English
6.1. STARTING AND STOPPING
Starting the machine:
Press the on / off
button for one second
and release. The LED
indicator will light red and
then green while you will
hear a short beep. This
green light will indicate
the percentage of battery
charge
Press the trigger twice in
a row. Then the scissor blade will open and is ready
to cut.
Machine stop:
Press the trigger for 2 seconds. After 1 second you
will hear 2 short "beep" sounds and one second later
two more short "beep" sounds. At this point, release
the trigger and the cutting blade will stay closed.
Press the On / Off button. The LED indicator will turn
off.
6.2. CUT SIZE ADJUSTMENT
This scissor has two cut sizes 20/30 mm. To vary the
cut size, press the trigger and hold it for one second
until you hear 2 short beeps. Then release the trigger
and the cut size will have varied.
6.3 ANTI-CUT SECURITY SYSTEM
This scissor has an anti-cut system, which works
only and exclusively with the user who is using the
scissors and as long as they are not wearing gloves.
This system comes into operation when it touches
the blade or fixed blade (1/2) at the same time as
the trigger (4). To activate or deactivate the anti-cut
system, hold down the trigger. After a second you will
hear two short "beeps", a second later another two
short "beeps", then you will hear a long "beep". After
this long beep you will have activated / deactivated
this function. Press the trigger again twice in a row to
continue working.
This machine also has a security system that if it is
not used after 3 minutes, it automatically goes to
sleep warning you with 2 "beep"
After 10 minutes of rest, the machine will turn off,
warning it with 4 "beep"
7. MAINTENANCE AND SERVICE
Removal of safety devices, improper maintenance,
replacement of bar and / or chain with non-original
spare parts can lead to severe bodily injury.
Always perform maintenance or service with the
battery unplugged.
Carry out the following maintenance and care
operations when you finish working with the machine
to ensure the smooth operation of this machine in
future occasions.
7.1. LUBRICATION
The lubrication of the area of the blades is essential
to guarantee the life of the blade and the scissor
motor. Lubricate the gear with liquid lithium grease
by introducing a few drops into the lubrication hole,
always before starting work and every 10 minutes of
work. Never apply grease to the blades.
28/84