Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
CAUTION:
Always be sure that the machine
is switched off and the battery cartridges are
removed before carrying out any work on the
machine.
Before installing or removing the carrier, bucket, flat
bucket, or dump unit, be sure to lock the brake lever.
To lock the brake lever, pull and hold the brake lever,
then pull the lock lever, and then release the brake lever
while pulling the lock lever.
2
Fig.7
► 1. Brake lever 2. Lock lever
Installing or removing the dump unit
Optional accessory
Installing the dump unit
1.
Take out the dump unit and the handle from the
box.
Fig.8
► 1. Dump unit 2. Handle
2.
shown in the figure, and then tighten 4 bolts securely.
1
Fig.9
► 1. Bolt 2. Handle
NOTE: When tightening the bolts, lift the handle
slightly.
3.
down the handle.
Fig.10
1
► 1. Handle
4.
corner on the rear of the machine.
2
Fig.11
► 1. Cord cover
11 ENGLISH
Insert the pipes of the handle into the dump unit as
Make sure that the dump unit is locked by pulling
Remove the cord cover located in the lower right
1
1
2
1
Publicidad
