Makita XUC04 Manual De Instrucciones página 20

1
Fig.40
► 1. Rear lamp
NOTE: The lamps go off if the machine is not oper-
ated for a certain period.
NOTE: The lamps go off when the power is turned off.
NOTE: You can light up the lamps even if the lock key
is not inserted.
Switch trigger and brake lever
CAUTION:
Before installing the battery car-
tridge into the machine, always check to see that
the switch trigger actuates properly and returns
to the "OFF" position when released.
To start the machine, pull the switch trigger. Using the
switch trigger, the speed can be adjusted within the set
speed range. To stop the machine, release the switch
trigger and pull the brake lever.
To lock the brake lever, pull and hold the brake lever,
then pull the lock lever, and then release the brake lever
while pulling the lock lever. To release the lock, pull the
brake lever.
1
Fig.41
► 1. Switch trigger
Fig.42
► 1. Brake lever 2. Lock lever
Adjusting the width of the carrier
NOTICE:
Make sure that the side rails and front
rail are fixed securely after tightening the thumb
nuts.
Loosen 6 thumb nuts, and then slide the side rails and
front rail. Tighten the thumb nuts to fix the side rails and
front rail.
Fig.43
► 1. Thumb nut 2. Rail
CAUTION:
Do not slide the rails beyond the
limit mark.
Fig.44
20 ENGLISH
2
1
1
2