MPM MRK-17 Manual De Instrucciones página 21

Paying attention to the cuts, put the insert of choice (9a, 9b) into the attachment (7). Then
hold the rotating cogged handle, put the stainless steel knives (8) on the attachment (7)
and block it with 4 clamps (10).
Place the container (11) on a dry and firm surface.
fig. 1
Put the attachment with the chosen insert and rotating knife into the container (11), so
that sockets in the attachment are properly fixed on the insets on the inside of the con-
tainer. Pay atten tion to the marks on the appliance (fig. 4). Before
replacing the lid make sure the clamps (10) are in the closed po-
sition (fig. 1). Put the lid (13) on the container paying attention to
the marks on it and on the handle (fig. 2). Then turn it fully clock-
wise so that the sign of "triangle"
of "closed lock" (fig. 3). You will hear a click.
Make sure every part is correctly fixed and replace the blend-
er housing (1). It gets blocked the moment it is pushed into the
mounting socket (15) in the container lid.
Insert the plug into the power outlet.
In order to start the appliance press and hold down the switch (4) or (5).
Put the products to be cut into the food chute (14). You can lightly push them with the
pusher or cut into smaller pieces earlier on, if necessary.
In order to detach the blender from the lid, push the lock release (3) and pull it out.
In order to open the lid (13) push the lock release button (12) and turn the lid home, coun-
ter-clockwise (fig. 2)
To disassemble the cutting attachment reverse the assembly procedure.
The MRK-17 food processor is provided with additional stainless steel mixing attachment,
designed for work in high temperatures (2), container with a lid, 400 ml, (19) with stainless
steel chopping and grinding knife (20), additional container with a lid, 600 ml (22), whisk-
ing attachment (21) and dough hook (23).
ASSEMBLY OF THE CUTTING ATTACHMENT
Fix the mixing attachment (2) to the blender housing (1). The mixing attachment gets
blocked the moment it is pushed into the blender housing (1). To remove the mixing at-
tachment (2), push the lock release buttons (3) and remove it, keeping the blade down-
ward. Make sure to avoid cutting yourself while removing the attachment and damaging
any part.
fig. 2
is directed towards the sign
fig. 3
fig. 4
21
EN