Publicidad
Idiomas disponibles
Idiomas disponibles
EN
5. OPERATION
ATTENTION
The protection class of ECOMIG Series Inverter MIG/MMA Welder is IP21. It is forbidden to put in a finger or insert a
round bar less than 12.5 mm (metal bar in particular) into the welder. No heavy force can be employed on the welder.
5
9
4
2
1
*According to the model and with
TIG TORCH accessory (not supplied)
ATTENTION
• The 'protection indicator light' will be on after a long time operation, it shows that the inner temperature is over the
permitted data, then the machine should be stopped using for some time to let it cool down. It can continue using after
the 'protection indicator light' is off.
• The power source should be switched off after the operation or while temporarily leaving job site.
• Welders should dress canvas work cloth and wear welding mask to prevent the hurt from arc and thermal radiation.
• Light separating screen should be put in the job site to prevent the arc will hurt other people.
• Inflammable or explosive materials are prohibited to access the job site.
• Each connection of the welder should be connected correctly and creditably.
Work piece cleaning before welding
Wire, groove and surrounding 10-20mm site must be cleaned, no existing rust, greasy dirt, water and paint etc.
15
7
8
10
6
11
3
12
1. Wire feeder wire
2. Mig torch connector
14
3. Welding voltage potentiometer
4. Welding current potentiometer
5. Current digital meter
6. Voltage digital display meter
7. Work indicating lamp
8. Protection indicator
9. 2S/4S
13
10. Adjust switch for MIG/MMA/TIG*
11. Inductive potentiometer
12. European fast socket
13. Fan
14. Input cable
15. Power switch
12
Publicidad
