Publicidad
Idiomas disponibles
Idiomas disponibles
EN
5.1 mig Welding steps
Debugging before welding
• Install the torch, gas and welding wire, and then turn on the power switch. The power indicator is on and fan works.
• Turn on the gas regulator of gas tank, the gas pressure is shown on the meter.
• Turn the gas regulator anticlockwise, loose the wire roller, press down the torch switch, and then adjust the gas flow to meet the
technics requirement, and then repress the wire roller.
• Press the torch switch till the wire extends to the nozzle.
• When wire feeding, make the cable straight.
• When wire feeding, make sure the wire is located on the wire roller groove reliably and the feeding speed should be smooth. If
the wire feeding speed is not smooth, please adjust the tension of the wire roller.
• When using MIG wire, the V groove wire roller should be used.
Welding
• When welding, please adjust the welding current and welding voltage matchable according to the set-up.
• Aim at the welding line, press down the torch switch, the wire feeds automatically. The arc is started once the wire is touched the
work piece. When welding, the "working indicator" is ON.
5.2 flux core Welding steps
Debugging before welding
• Change the polarity on the vertical board, it is, connect MIG torch lead to "-", the ground cable lead to "﹢".
• Install the torch, gas and welding wire, and then turn on the power switch. The power indicator is on and fan works.
• Press the torch switch till the wire extends to the nozzle.
• When wire feeding, make the cable straight.
• When wire feeding, make sure the wire is located on the wire roller groove reliably and the feeding speed should be smooth. If
the wire feeding speed is not smooth, please adjust the tension of the wire roller.
• When using flux wire, the gear type groove wire roller should be used.
Welding
• When welding, please adjust the welding current and welding voltage matchable according to the set-up.
• Aim at the welding line, press down the torch switch, the wire feeds automatically. The arc is started once the wire is touched the
work piece. When welding, the "working indicator" is ON.
5.3 aluminum Welding steps
Debugging before welding
• Change the liner in MIG torch for Telfon liner.
• Connect the torch, gas hose, grounding cable, argon gas tank, work piece and then turn on the power switch, the power indicator
is on, at this time, the fan is working.
• Turn on the gas regulator of gas tank, the gas pressure is shown on the meter.
• Turn the gas regulator anticlockwise, loose the wire roller, press down the torch switch, and then adjust the gas flow to meet the
technics requirement, and then repress the wire roller.
13
Publicidad
