Roborock S8 Pro Ultra Manual Del Usuario página 10

Child Lock
Press and hold the button to enable/disable
the child lock. You can also set it in the app.
Once enabled, the robot will not react to
button presses when it is stationary. When the
robot is cleaning or docking, press any button
to stop it.
Error
If an error occurs, the power indicator light
on the robot will flash red or status indicator
light on the dock will be steady red. A pop-up
notification will receive in the app and a voice
alert may sound.
Notes:
• The robot will go to sleep automatically if left in a
malfunctioning state for over 10 minutes.
• Placing a malfunctioning robot on the dock manually will
end the current cleanup.
System Reset
If the robot does not respond when a button
is pressed or cannot be turned off, reset the
system. Press the Reset button, and the robot
will reset automatically.
Note: After resetting the system, scheduled cleaning, WiFi,
etc. will be restored to factory settings.
Restore Factory Settings
If the robot does not function properly after a
system reset, switch it on. Press and hold the
button and at the same time, press the Reset
button until you hear the "Restoring factory
settings" voice prompt. The robot will then be
restored to factory settings.
Routine
C
Maintenance
Main Brushes
C1
* Clean every 2 weeks and replace every 6-12 months.
C1-1—Main Brushes
C1-2—Main Brush Cover
C1-3—Latches
C1-4—Main Brush Bearing
C1-5—Main Brush Caps
C1-6—Turn over the robot and press the
latches to remove the main brush
cover.
C1-7— Remove the main brushes and pull
out the main brush bearing.
C1-8— Pull out the main brush caps.
C1-9— After removing the tangled hair or
dirt at both ends of the main
brushes, reinstall it.
C1-10— Press on the main brush cover until
you hear it lock the brush in place
with a click.
Notes:
• Main brushes should be wiped down with a wet cloth and
left to dry away from direct sunlight.
• Do not use corrosive cleaning fluids or disinfectants to
clean the main brushes.
10
Side Brush
C2
* Clean monthly and replace every 3-6 months.
1. Unscrew the side brush screw.
2. Remove and clean the side brush.
Reinstall the brush and tighten the screw.
Omnidirectional Wheel
C3
* Clean as required.
C3-1— Use a tool, such as a small
screwdriver, to pry out the axle and
take out the wheel.
Note: The omnidirectional wheel bracket cannot be removed.
C3-2— Rinse the wheel and the axle with
water to remove any hair and dirt.
Dry and reattach the wheel, pressing
it firmly in place.
Main Wheels
C4
* Clean monthly.
Clean the main wheels with a soft, dry cloth.