Roborock S8 Pro Ultra Manual Del Usuario página 12

Replacing the Disposable
C14
Dust Bag
* Replace the disposable dust bag when it is full.
C14-1— Lift the dustbin and remove the
bag vertically as shown.
Note: Pulling the dust bag handle to remove the bag will seal
the bag to prevent leakage.
C14-2— Discard the dust bag and clean
around the filter with a dry cloth.
C14-3— Slot in a new disposable dust bag
as shown. Slide until it reaches the
bottom of the slot and reinstall the
dustbin securely.
Note: Always install a dust bag before putting back the
dustbin top lid to avoid auto-emptying without the bag. You
can also disable auto-emptying in the app.
Cleaning the Air Duct
C15
* Clean as required.
Follow the following steps to clean the air
duct and avoid blockages.
Remove the clean water tank, dirty
C15-1—
water tank, and dustbin.
C15-2— Remove the water filter and wipe
off any water marks with a cloth.
C15-3— Grasp the sides of the dock base
upward to disassemble and check
any blockage. Clean the air inlet
with a cotton swab if it gets blocked
and wipe it with a dry cloth.
C15-4— Carefully place the dock upside
down on a hard floor covered with
a soft towel.
C15-5— Unscrew the three screws and
remove the cover.
C15-6—
Wipe the air duct and duct cover
with a dry cloth.
C15-7— Reinstall the cover and screw it
back in place.
12
Basic Parameters
Robot
Model S81USP
14.4V/5200mAh (TYP)
Battery
lithium-ion battery
Rated Input 20VDC 1.5A
Charging Time Approx. 4 hours
Note: The serial number is on a sticker on the underside of
the robot.
Empty Wash Fill Dock
EWFD07HRR,
Model
EWFD08HRR
Rated Input Voltage 220-240VAC
Rated Frequency 50-60Hz
Rated Input
5A
(Dust Collection)
Rated Input
0.65A
(Non-Dust Collection)
Rated Output 20VDC 1.5A
14.4V/5200mAh (TYP)
Charging Battery
lithium-ion battery