Roborock S8 Pro Ultra Manual Del Usuario página 11

Dustbin
C5
* Clean as required.
C5-1— Open the top cover of the robot and
press the dustbin latch to take out
the dustbin.
C5-2— Press the cover latch to open the
dustbin cover and remove the
washable filter, then empty the
dustbin.
C5-3— Fill the dustbin with clean water and
close the cover. Gently shake the
dustbin, and then pour out the dirty
water.
Note: To prevent blockage, only use clean water without any
cleaning liquid.
C5-4— Leave the dustbin and the washable
filter to dry.
Washable Filter
C6
* Clean every 2 weeks and replace every 6-12 months.
C6-1— Open the filter cover and remove
the filter.
C6-2— Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
Note: Do not touch the surface of the filter with your hands,
brush, or hard objects to avoid potential damage.
C6-3— Allow 24 hours for the filter to dry
thoroughly and reinstall it.
Note: Purchase an additional filter and alternate if necessary.
VibraRise Mop Cloth
C7
* Clean as required and replace every 3-6 months.
C7-1— Remove the VibraRise mop cloth from
the VibraRise mop mount. Clean the
VibraRise mop cloth and air-dry it.
Note: A dirty VibraRise mop will affect the mopping
performance. Clean it before use.
Robot Sensors
C8
* Clean as required.
Use a soft, dry cloth to wipe and clean all
sensors, including:
C8-1— Wall Sensor
C8-2— Reactive 3D Obstacle Avoidance
Sensor
C8-3— Carpet Sensor
C8-4— Cliff Sensors
C8-5— Mop Wash Sensor
Charging Contact Areas
C9
* Clean as required.
Use a soft dry cloth to wipe the charging
contacts on the robot and the dock.
Battery
The robot is equipped with a built-in high-
performance lithium-ion rechargeable
battery pack. To maintain battery
performance, keep the robot charged
during normal use.
Note: If the robot will be left unused for a long period, turn it
off and charge it at least every three months to avoid battery
damage caused by over-discharge.
11
Moving the Dock
C10
Remove the water tanks and the dustbin
before moving the dock. Grip the handle on
the back with one hand and the inner side
of the front, as shown. Do not grip the base
because it is not designed for lifting.
Dirty Water Tank
C11
* Clean as required.
Clean the dirty water tank as needed. Open
the dirty water tank lid and pour out the
dirty water. Fill the tank with clean water,
close the lid, lock it, and shake. Pour out the
dirty water. Close the lid and then re-install.
High-Speed Maintenance
C12
Brush
* Clean as required and replace every 6-12 months.
Lift the high-speed maintenance brush latch
and remove the brush, as shown below.
Remove any entangled objects in the high-
speed maintenance brush and rinse it clean.
Reinstall the brush and latch it in place.
Water Filter
C13
* Clean as required.
Unlock the water filter and remove it from
dock. Unlock the filter latch, rinse the filter
clean. Use a soft, dry cloth to wipe the
cleaning tank, and then reinstall the filter.
Press down the filter until you hear it lock
with a click.