HOMCOM A90-256 Manual De Instrucciones página 21

ASSEMBLY INSTRUCTIONS
Assembly step 1
A.) Front Stabilizer Assembly
Please note, the Front Stabilizer(#02A) is the one with end caps that spin for ease of
relocating the unit as referred to in illustration below.With the help of an assistant,
attach the Front Stabilizer(#02A) to the front of Main Frame(#01)as illustrated below
using two Carriage Bolts(#35),two Arc Washers (#47), two Spring Washers(#52), and two
Nuts(#43).
B.) Rear Stabilizer Assembly
Attach the Rear Stabilizer(#02B) to the back of Main Frame(#01) as illustrated below
using two Carriage Bolts(#35), two Arc Washers(#47),two Spring Washers(#52), and two
Nuts(#43).
Note:If a slightly rough, Can adjust the pipe plug(24).
Bolt
#35 Carriage Bolt(M8*75MM)
[4 pieces]
Hardware Required
Washer
#47 Arc Washer (M8)
[4 pieces]
-21-
#52 Spring Washer (M8)
[4 pieces]
Nut
#43 Nut (M8)
[4 pieces]