HOMCOM A90-256 Manual De Instrucciones página 22

ASSEMBLY INSTRUCTIONS
Assembly step 2
Remove the pre-assembled parts from Main Frame(#01) and set them aside nearby: SixBolts
(#38),six Spring Washers(#52), and six Arc Washers(#47). With the help of an assistant,
connect Monitor Wire(Middle)(#20) to Monitor Wire(Lower)(#19) as show in exploded diagram
A, and Tension Controller(#17) to Tension Controller Cable(#18) as shown in exploded
diagram B.Then, being careful to tuck the connected wires into the hollow tubing to avoid
pinching/damaging the wires, slide Center Post(#03) onto the protruding tube of Main Frame
(#01). Secure using a total of six Bolts(#38), six Spring Washers(#52), and six Arc Washers
(#47) that were set side nearby.
Bolt
#38 Bolt (M8*15MM)
[4 pieces]
Nut
#46 Nylon Nut (M8)
[2 piece]
Hardware Required
Washer
#58 Bolt (M8*70MM) #47 Arc Washer (M8)
[2 pieces] [8 pieces]
-22-
#52 Spring Washer (M8)
[4 pieces]