YABER YA30 Manual Del Usuario página 9

Notes on Charging Your Car Battery
1. Use the original smart clip to start the car.
2. DO NOT use this unit if any cable clamp or cord is damaged.
3. Start only for 12V vehicles,or it will cause serious damages to the unit.
4. Do not jump start your car when the battery capacity is lower than 50%.
5. Do not connect two clamps together when the starter is powered on. And
do not connect both cable clamps to the same piece of metal.
6. If the engine does not start on the first try, disconnect it from the car
battery and wait for at least 20 seconds before reconnecting. Maximize
three attempts in two minutes.
7. Once the engine is successfully started, disconnect the clamps within 30
seconds.
Model
Output1
Output2
Input
DC Output
Short circuit protection
Input Low-voltage protection
Over-temperature Protection
Reverse polarity protection
Input High-voltage protection
Dimension
Max air pressure
support@ibuture.com
support@yaberauto.com
YA30
5V 2.1A
5V 2.4A / 9V 2A / 12V 2A
5V/2A 9V/2A
12V-16.8V 3A
√
14.0v ± 0.5v
＞65 ℃ ± 5 ℃
√
17.5v ± 0.5v
9.29 in (L)x7.44 in (W)×3.31in(H)
150 PSI
EN 07