Power Connection - Tennant ORBIO OS 3 Manual Del Operario

POWER CONNECTION

The voltage indicated on the type plate must correspond to the
voltage of the electrical source.
Safety class I appliances may only be connected to sockets with
proper grounding.
It is recommended that you connect this device to a socket that
has a 30 mA protection switch against wrong currents.
WARNING: Electrical Hazard.
Do not modify plug. If the power cord is damaged or broken, it
must be replaced by the manufacturer or its service agent or a
similarly qualified person in order to avoid hazard.
The appliance may only be connected to an electrical supply which
has been installed by an electrician in accordance with IEC 60364.
FOR SAFETY:
1 Do not operate machine:
− Unless trained and authorized.
− Unless operator manual is read and understood.
− Under the influence of alcohol or drugs
− Unless mentally and physically capable of following
machine instructions.
− If it is not in proper operating condition.
− In outdoor areas. This machine is for indoor use only.
− If water supply is turned off, unplug machine until water
supply is restored, then plug machine in.
2 When using machine:
− Use only as described in this manual.
− Do not use water softener as a step.
− Keep children and unauthorized persons away from
machine.
− Do not allow to be used as a toy.
− Follow site safety guidelines concerning wet floors.
3 When servicing machine:
− Unplug cord from wall outlet.
− All work must be done with sufficient lighting and
visibility.
− All repairs must be done by trained personnel.
− Do not modify the machine from its original design.
− Use Tennant supplied parts or approved replacement
parts.
− Do not remove e−module unless operator manual is read
and understood.
4 When using MultiSurface Cleaner:
− Do not mix with other cleaning products.
− Do not drink.
− Refer to SDS (Safety Data Sheet) for additional safety
information and precautions.
os3 DM20038 (6−2014)
Grounded
Grounded
− Wear personal protection safety equipment as needed.
5 When using MultiMicro 200 Solution:
− Do not mix this product with ammonia or acid which will
produce chlorine gas.
− Do not mix with other cleaning products.
− Do not drink.
− Refer to SDS (Safety Data Sheet) for additional safety
information and precautions.
− Wear personal protection safety equipment as needed.
For Safety: wear protective gloves.
For Safety: wear eye protection.
− Refer to MSDS (Material Safety Data Sheet) for additional
safety information and precautions.
FOR SAFETY: When servicing machine, do not remove
e−module unless operator manual is read and understood.
FOR SAFETY: When using machine, do not use water
softener as a step.
SAVE THESE INSTRUCTIONS
English EN
3