Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
Workpiece contact does not depress
fully - tool does not operate
Tool operates properly, but nails do not
drive fully
Tool operates properly, but nails are
driven too deep
Tool jams frequently
Tool stops and LED flashes rapidly
Tool has charged battery and LED is
slowly flashing or LED does not turn
off after approximately ten seconds of
non-use
LED LIGHT FUNCTIONS
Tool Status
Normal
Low Battery
Jam Mode
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
TROUBLESHOOTING
POSSIBLE CAUSE
Low nails
Work-contacting element is jammed
Air pressure is too low
Depth of drive isn't deep enough
Nail is too long for wood hardness
Trigger released too soon
Battery pairing is unsuitable
Depth of drive is too deep
Incorrect nails
Damaged nails
Loose magazine
Dirty magazine
Battery is low or has no charge
Trigger released too early
Tool has malfunctioned
LED Light Scenario
Solid Green Light (No Flashes)
Solid Red Light (No Flashes)
Flashing Red Light
NOTE: ILLUSTRATIONS START ON PAGE 13
12 — English
SOLUTION
Remove battery and replenish nails
Remove battery and clear jam
Refill air pressure tank
Adjust depth of drive
Use nail length that is appropriate for
wood
Hold trigger until fastener is driven
Use a 3Ah battery or higher
Adjust depth of drive
Verify that nails are the correct size
Replace nails
Tighten screws
Clean magazine
Recharge battery
Remove battery and reinstall.
Take tool to nearest authorized repair
center
Action Required
No Action Needed
Recharge or Replace Battery. If prob-
lem persists, contact an authorized
service center for repair.
Clear Jam – See Clearing a Jammed
Fastener in Operations.
Publicidad
