Sound Active Mode; Slave Mode; Static Color Mode - TECshow QUADBAR 12 PIX Manual De Usuario

Sound active mode

a. Press the mode button to enter sound active
mode Sound.
b. Press the setup button to enter sound active
mode1 5-.31 (Controlling sensitivity of the
jumping music on the direction of ---]). Press
the up or down button to set sound active sen-
sitivity 5-.00 ~ 5-.31. The maximum is 31.
c. Press the setup button to enter sound active
mode2 5-.31 (Controlling the sensitivity of the
stamping music on the direction of [--- ). Press
the up or down button to set sound active sen-
sitivity 5-.00 ~ 5-.31. The maximum is 31.
d. Press the setup button to enter sound active
mode3 effect program 5-31. Press the up or
down button to set sound active sensitivity
5-.00 ~ 5-.31. The maximum is 31.
e. Press the setup button to enter stamping direc-
tion of the voice frequency. And then select [---
& ---] to adjust stamping direction.

Slave mode

Press the mode button to enter slave running mode
"Slav".
The slave will follow up the main lighting with the
same effect programs.

Static color mode

a. Press the mode button to enter static mode
"Colr".
b. Press the setup button to select static color
r.255, 9.255, b.255, u.255. And press the up or
down button to set dimming value respectively
r.000 - r.255, 9.000 - 9.255, b.000 - b.255, u.000 -
u.255.
Design and product specifications are subject to change without prior notice.
P. 6
Tecshow Quadbar 12 Pix | English version
Restore factory setting
When the fixture is power off, please press the
mode and up button at the same time. And then
give it power supply for 5s. After loosen buttons,
it can restore factory setting and display program
version numbers. The lighting will operate auto
running mode.
Remarks
a. If you don't press any button in 20s, the dis-
play panel will become dark. At this time, you
can press any button to show current status
and adjust corresponding modes and opera-
tion status.
b. When the lighting is power on, please press
the mode or setup button. The LED display
will show temperature detection value. If you
don't press any button, it will just show ver-
sion number. (If the temperature is abnormal,
the detection will show 1.Er, and the lighting
will be red 3s.).