Publicidad
Idiomas disponibles
Idiomas disponibles
Before using the appliance, READ ALL INSTRUCTIONS and wash the filter
1.
basket, pump tube, and inside of urn body with non-abrasive detergent. Wipe dry
with soft cloth. Try not to get water into the base of the appliance.
Remove lid and filter basket. Fill with COLD WATER to desired amount on water
2.
gauge. Do not fill more than the MAXIMUM fill mark on water gauge or operate
when the level is below the bottom graduation of the water gauge.
Place filter basket on tube and insert pump tube firmly into the heating element
3.
inside the urn body to assure proper pump action.
Add coffee grounds evenly into filter basket. (1 Tbsp = 1 cup or to taste). NOTE: To
4.
heat only water, do not add coffee grounds to basket.
5.
Place lid in position and turn clockwise to lock into place.
6.
Check power switch is OFF position. Plug cord into grounded 120V. electrical
outlet. Press power switch ON, the red HEATING light will turn on to indicate start
of brew cycle.
When finished brewing the amber KEEP WARM light will turn on indicating
7.
contents are ready to serve and will keep contents warm until unit is turned OFF.
During the warm cycle you may hear noises similar to brewing, this is normal and
the unit is not brewing but only keeping contents warm.
8.
NEVER OPERATE APPLIANCE EMPTY. This can damage the heating element
and void warranty.
Resetting appliance overheat protection device
This appliance has an overheat protection device that will automatically stop heating if
operated without enough water or ambient temperatures are too high.
• To reset - Remove cord from electrical outlet and allow appliance to cool. Tilt unit and
located under the base is a button that must be pressed once to reset device.
• Check that the switch is in OFF position and insert cord into grounded 120V electrical outlet.
• If this does not work, contact The Metal Ware Corporation Customer Service Center
(800) 288-4545 or nesco.com for repair.
1. Always turn OFF the power switch then unplug appliance before cleaning.
2. Empty remaining liquid by removing lid, basket and pump tube and pouring liquid into drain.
3. Clean the surfaces with clean, damp, soft cloth or sponge. Never place base of
appliance in water or other liquids.
4. Never use abrasive cleaners or scouring pads. DO NOT use Baking Soda because it
can pit the metal and discolor permanently.
5. Allow to dry before storage.
6. Some water has higher mineral content that can discolor the inside of the urn body. To
remove these stains fill to desired level with COLD WATER use several tablespoons of
vinegar or Cream of Tartar powder. Allow to heat for one BREW cycle, then turn power
OFF and remove plug from wall outlet. Drain solution, rinse and clean as noted above.
Operation
Care and Cleaning Instructions
3
Publicidad
