Installing The Receiver Module - Phonic UM30 Manual Del Usuario

Micrófono inalámbrico
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installing the Receiver Module

For UM 31��41��51
Active Performer Spea��ers
Remove the compartment cover on the left
side of Performer speaker (left when facing
the rear). Remove the grounding PCB from
the golden finger socket. Insert the UM-R11 re-
ceiver into the module compartment, and use a
screw to secure it into place. Replace the com-
partment cover.
RoadGear 120, 160 and 260
Opening the storage compartment on the rear
of the RoadGear's mixer, users will notice 2
module slots available. Insert the UM-R11 re-
ceiver module into one of these, use a screw to
secure it into place and close the compartment
again.
UM 30/31/40/41/50/51
Powerpod 865 and 885 Plus
Open the wireless module compartment by
removing the single screw. Slide the UM-R11
module along the wall of the compartment door
and into the port connected to the door. Close
the compartment door and replace the screw.
For UM 30��40��50
Sound Ambassador 75��120 Deluxe
Remove the 2 screws at the top of the protec-
tive cover, and remove the grounding PCB
from the compartment. Place the UM-R10 re-
ceiver into the slot revealed after removing the
cover, and screw the front panel of the receiver
in place.
11

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Um31Um40Um41Um50Um51

Tabla de contenido