YATO YT-82133 Manual De Instrucciones página 10

PRODUCT CHARACTERISTICS
A demolition hammer is an ordinary power tool of II class of insulation, designed for demolition and chiselling works in natural
stone, artifi cial stone, marble etc. using work tools fi tted with a hexagonal grip. Correct, reliable and safe operation of this power
tool depends on proper operation, therefore:
Before starting the work with this product, please read this manual and keep it properly.
The supplier does not assume any liability for damages resulting from failure to follow safety regulations and recommendations
specifi ed in this manual.
EQUIPMENT
The product is supplied as complete, the packaging should include:
- demolition hammer
- auxiliary grip handle
TECHNICAL PARAMETERS
Parameter
Catalogue number
Rated voltage
Rated frequency
Rated power
Impact frequency
Single impact energy
Weight
Noise level
- acoustic pressure
- power
Vibration level
Insulation class
Protection class
Hexagonal tool chuck
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
Keep all warnings and instructions for future reference.
The term "power tool" used in warnings applies to all tools driven by power both wired and wireless.
Workplace safety
Keep the workplace well-lit and clean. Disorder and poor lighting can be causes of accidents.
Do not work with power tools in an environment with an increased risk of explosion, containing fl ammable liquids, gases
or vapors. Power tools generate sparks that can ignite dust or fumes.
Children and third persons should not be allowed to enter the workplace. Loss of concentration can result in loss of control.
Electrical safety
The plug of the electric cable must match the power socket. You must not modify the plug in any way. Do not use any
plug adapters with earthed power tools. An unmodifi ed plug that fi ts the outlet reduces the risk of electric shock.
Avoid contact with earthed surfaces such as pipes, radiators and coolers. Grounding the body increases the risk of electric shock.
Do not expose power tools to contact with atmospheric precipitation or moisture. Water and moisture that gets inside the
power tool increases the risk of electric shock.
Do not overload the power cable. Do not use the power cord to carry, pull or unplug the power plug from the power outlet.
Avoid contact of the power cable with heat, oils, sharp edges and moving parts. Damage or entanglement of the power cord
increases the risk of electric shock.
In the case of working outside closed rooms, use extension cords intended for work outside closed rooms. The use of an
extension cord adapted for outdoor use reduces the risk of electric shock.
When using a power tool in a humid environment is unavoidable as a protection against supply voltage use a residual
O R I G I N A L
10
EN
Measuring unit
[V~]
[Hz]
[W]
[min -1 ]
[J]
[kg]
[dB]
[dB]
[m/s ]
2
[mm]
I N S T R U C T I O N S
Value
YT-82133
220 - 240
50
1150
4850
15
4,8
83,5 ± 3,0
97,5 ± 2,4
15,546 ± 1,5
II
IPX0
SDS MAX