Orbegozo RJ 1000 Manual De Instrucciones página 14

Idiomas disponibles

RJ 1000

5. Once you have finished using your heater, turn the power switches, and the thermostat control

switch to the "0" position, and unplug from the mains supply.

Note: This radiator heater is oil filled, and will cool down slowly after the power is shut off. Allow the

radiator heater to cool prior to any movement; the built carry handle should be used for easy

movement. Do not cover the heater at any time during operation. There is a risk of fire if the heater is

covered.

CLEANING YOUR OIL RADIATOR

1. Always disconnect the heater from the mains supply before cleaning.

2. Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth.

3. DO NOT use waxes or polishes as these may react with the heater and cause discolouration.

STORING YOUR OIL RADIATOR

1. Save the box for off season storage.

2. Clean the heater following the cleaning instructions above.

3. Remove the wheel base assemblies.

4. Place the radiator, and wheel assemblies in the original box, and store in a cool and dry place.

5. If you choose to store your heater fully assembled, be sure to cover it to protect it from dust.

Disposal of old electrical appliances.

The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires

that old household electrical appliances must not be disposed of in the normal unsorted

municipal waste stream. Old appliances must be collected separately in order to optimize the

recovery and recycling of the materials they contain, and reduce the impact on human health and

the environment. The crossed out "wheeled bin" symbol on the product reminds you of your

obligation, that when you dispose of the appliance, it must be separately collected. Consumers

should contact their local authority or retailer for information concerning the correct disposal of their old

appliance.

DECLARATION OF CONFORMITY:

This device complies with the requirements of the Low Voltage Directive 2014/35/EUand the

requirements of the EMC directive 2014/30/EU.