Publicidad
Idiomas disponibles
Idiomas disponibles
Downloaded by: pd-oliana on 07-03-2023 10:29 CET
2. Remove the knob from the gas tap.
3. Use an appropriately sized screwdriver to adjust the flow rate adjustment screw. For LPG (butane-pro pane)
turn the screw clockwise. For the natural gas, you should turn the screw counter- clockwise once.
"The normal length of a straight flame in the reduced position should be 6-7 mm."
4. If the flame is higher then the desired position, turn the screw clockwise. If it is smaller turn anticolockwise.
5. For the last control, bring the burner both to high-flame and reduced positions and check whether the flame
is on or off.
Depending on the type of gas tap used in your appliance the adjustment screw position may vary.
To adjust your oven acc. to the gas type, make the adjustment for reduced flame carefully by turning with
a small screwdriver as shown below on the screw in the middle of the gas cocks as well as nozzle chang-
es. (figure 6 and 7)
Figure 6
Figure 7
Removal of the lower and upper burner and installation of the injector to the gas oven
Removal of the upper burner:
With the help of a screw driver, remove the screw as shown in figure 8. As shown in figure 9, remove the burner
from its place by pulling it to yourself. As shown in figure 10, remove the injector in the bearing with a socket
wrench. In order to re-place the burner, apply the removal process reversely.
Figure 8
Figure 9
Figure 10
Removal of the lower burner:
The lower burner door has been fixed with two screws. As shown in figure 11, remove it with the help of a
screw driver. Remove the door by pulling upwards as shown in figure 12. Remove the burner from its place by
pulling it to yourself as shown in figure 13. As shown in figure 14, remove the injector in the bearing with a socket
wrench. In order to replace the burner, apply the removal process reversely.
Publicidad
