Bosch PROFESSIONAL GNF 65 A Instrucciones De Servicio página 10

Tool Specifications
Wall Chaser
Order number
Rated input power
Output power
No-load speed
Diamond cutting
discs Ø, max.
Mounting hole
Slot depth
Slot width
Weight without
cable, approx.
Protection class
Please observe the order number of your machine.
The trade names of the individual machines may vary.
Machine Elements
The numbering of the machine elements refers to
the representation of the machine on the graph-
ics page.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
1 On/Off switch
2 Cutting depth scale
3 Adjustment screw
4 Quick-clamping lever for protective cover
5 Clamping nut
6 Spacer discs
7 Diamond cutting disc*
8 Mounting flange
9 Grinder spindle
10 Chaser rollers
11 Auxiliary handle
12 Locking screw for auxiliary-handle holder
13 Spindle lock button
14 Protective cover with cutting guide
15 Clamping lever for cutting depth
pre-selection
16 Extraction elbow
17 Vacuum hose*
18 Break-out tool
19 Two-pin spanner for clamping nut
* Not all of the accessories illustrated or described are
included as standard delivery.
10 • 3 609 929 352 • TMS • 19.08.03
GNF 65 A
PROFESSIONAL
0 601 368 7..
[W] 2 400
[W] 1 670
[rpm] 5 000
[mm] 230
[mm] 22.2
[mm] 20 – 65
[mm] 8 – 40
[kg] 8.4
/ II
general safety notes in the enclosed booklet
must be observed. Before using for the first
time, ask for a practical demonstration.
Wear protective glasses and hearing protec-
tion. Wear additional protection equipment for
your safety, such as protective gloves, sturdy
shoes, hard hat and apron.
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
If the mains cable is damaged or cut through
while working, do not touch the cable but im-
mediately pull the mains plug. Never use the
machine with a damaged cable.
Always direct the cable to the rear away from
the machine.
Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Do not op-
erate the machine in rain or moisture.
Do not work with materials containing asbes-
tos.
Only use diamond cutting discs with a maxi-
mum permissible speed that is at least as high
as the no-load speed of the machine.
Check the diamond cutting discs before use.
The diamond cutting discs must be mounted
properly and able to rotate freely. Carry out a
test run for at least 30 seconds without any
load. Do not use any diamond cutting discs
that are damaged, out-of-balance, or vibrate.
Observe the dimensions of the diamond cut-
ting discs. The hole diameter must fit the
mounting flange 8. Do not use any reduction
parts or adapters.
Protect diamond cutting discs against impact,
shock and grease.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
Apply the machine to the workpiece only when
switched on.
Keep hands away from the rotating diamond
cutting disc.
English - 1
For Your Safety
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the