Mains Connection - Festool MX 1200/2 E EF Manual De Instrucciones

* MX 1200/2 E EF / ** MX 1600/2 E EF
1st speed
150 – 360 rpm *
150 – 300 rpm **
The gears can be switched when the machine is
running down, however not under full load.
E R G O F I X interface
6.5
Height setting
The working height of the machine can be indi-
vidually adjusted to achieve an upright working
position.
 Push the casing of the E R G O F I X adapter
[1-7] in the direction of the machine to move it
as far as it goes [1-7] and hold it tight.
 By pulling on the stirrer rod, you can pull
the E R G O F I X adaptor [1-8] out of the ma-
chine spindle. In this way, you can adjust fi ve
different working heights. One step is 2 cm.
The maximum adjustment movement is 8 cm.
 Then release the clamping ring of the E R G O F I X
adapter [1-7] and check that the adapter [1-8]
is seated securely in the machine spindle.
Quick change function
NOTE
 Ensure that the adapter [1-8] remains clean.
 Do not lubricate the adaptor [1-8].
 Only press the E R G O F I X casing [1-7]
when the machine is not in operation.
The E R G O F I X interface enables you to eas-
ily and quickly remove the stirrer rod from the
machine.
 Push the clamping ring of the E R G O F I X
adapter [1-7] in the direction of the machine to
move it as far as it goes and hold it tight.
 By pulling on the stirrer rod, you can pull
the E R G O F I X adaptor [1-8] completely
out of the machine spindle.
Changing the stirrer
 Adapter E R G O F I X [2-1] after worn-out of
stirrer rod can be reused.
 Set the wrench [2-2] on the hexagon of the
stirrer endpiece [2-3] and turn to the left to
screw the stirrer rod out of the E R G O F I X
adapter [2-1].
6.6 Stirrer
To mix different material mixtures together, use
different Festool stirrers: see the catalogue
2nd speed
320 – 780 rpm *
320 – 650 rpm **
6.7

Mains connection

WARNING
There is a risk of accidents occurring if you do
not use the correct power supply.
13
PJ Uni
For wall paints,
emulsion paints,
ready-made fi ller,
ready-mix plaster,
varnishes/glazes
RS
For wall paints,
emulsion paints,
pastes, varnishes
casting compounds,
bitumen, sludges
HS2
For tile adhesives,
joint sealant, adhesive
mortar, ready-mix
plaster, screed, fi llers,
levelling compounds
HS3R
For mortar, concrete,
cement and lime
plaster adhesive fi ller,
screed, quartz-fi lled
epoxy resin, thick
bitumen coating
HS3L
For gypsum plaster,
emulsion paints,
varnishes wall paints,
casting compounds
WS
For paints, varnishes,
wall paints, emul-
sion paints, plasters,
glues, tile adhesives
CS
For balancing weights,
fi llers, sealants,
adhesives