Descargar Imprimir esta página

BTI EX 125-150 LV Manual Original página 31

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 12
Polishing
For the polishing of weathered paint or buffing out
scratches (e.g., acrylic glass), the machine can be
equipped with appropriate polishing accessories
such as lamb's wool bonnet, polishing felt or
sponge (accessories).
Select a low stroke rate (setting 1–2) for polishing
in order to avoid excessive heating of the surface.
Apply the polish onto a somewhat smaller surface
than you intend to polish. Work the polishing agent
in with a suitable polishing tool applying it cross-
wise or with circular motion and moderate pres-
sure.
Do not allow the polishing agent to dry out on the
surface, otherwise the surface can become dam-
aged. Do not subject the surface to be polished to
direct sunlight.
Clean the polishing accessories regularly to ensure
good polishing results. Wash out polishing acces-
sories with a mild detergent and warm water; do
not use paint thinner.
Application Table
The data in the following table are recommended
values.
The most favourable combination for working is
best determined by practical testing.
Intermediate varnish sanding
Varnish/glaze
Softwood
Hardwood
Veneer
Aluminium
Steel
Derusting steel
Stainless steel
Masonry, stone
1 609 92A 1SG • 11.11.15
Maintenance and Service
Maintenance and Cleaning
 Before any work on the machine itself, pull the
 For safe and proper working, always keep the
If the replacement of the supply cord is necessary,
this has to be done by BTI or an authorized BTI ser-
vice agent in order to avoid a safety hazard.
In all correspondence and spare parts orders,
please always include the 7-digit order number giv-
en on the nameplate of the machine.
Disposal
The machine, accessories and packaging should
be sorted for environmental-friendly recycling.
Do not dispose of power tools into household
waste!
Only for EC countries:
Subject to change without notice.
120/400
5/6
40/80
5/6
40/240
5/6
60/320
5/6
240/320
5/6
80/240
5
60/240
5
40/120
6
120/240
5
80/200
6
mains plug.
machine and ventilation slots clean.
According to the European Guideline
2012/19/EU for Waste Electrical and
Electronic Equipment and its imple-
mentation into national right, power
tools that are no longer usable must
be collected separately and disposed
of in an environmentally correct man-
ner.
English | 31

Publicidad

loading