Enerpac DGR-2 Manual De Instrucciones página 13

6. To program minimum graph percentage,
the display will indicate 0 0 with the right
digit fl ashing, the bottom most segment of
the bar graph will fl ash, and the display will
read "PCTFS" (percent full scale). Press
➟
▾
, to scroll to a number 0-9. Press
➟
| |
to select that number. The left digit
will now begin to fl ash. Press
to scroll to a number 0-9. Press
to select that number. The 2 digit number
entered represents the percentage of full
scale to be used as the low end of the graph
(0-99%).
7. To program maximum percentage of
full scale the display will indicate 1 0 0
with the right digit fl ashing, the upper
most segment of the graph will fl ash,
and the display will read PCTFS (percent
full scale). Press
a number 0-9. Press
that number. The left 2 digits will now
begin to fl ash. Press
scroll to a number 0-10. Press
to select that number. The number
entered represents the percentage of
full scale to be used as the high end of
the graph. Note: 100 is the highest and
only possible 3 digit number. If the low
number is equal to or larger than the
high number, the unit will fl ash "REJCT"
and it will exit back into the "GRAPH"
sub-menu.
Note: A display message "ULOCK" indicates
that custom units are being used and bar
graph minimum and maximum are set to the
factory defaults.
▴
➟
▴
▾
,
➟
| |
➟
▴
▾
, to scroll to
➟
| |
to select
➟
▴
▾
, to
➟
|
|
Reset:
Returns the product to the factory default values.
Preserves fi eld calibration. Factory calibration
can be restored in the "RECAL" menu.
In Menu mode press
"RESET" appears on display's lower line.
➟
| |
Press
Factory defaults pertain to units, timer,
backlight, update rate, zero lock.
Display will indicate "DONE" then gauge
will switch to "OFF" condition.
13
➟
▴
▾
,
.
until