Publicidad
Idiomas disponibles
Idiomas disponibles
Model: 6964
CleANING YoUR APPlIANCe
Clean your appliance after each use, after it is cool to the touch.
• do NoT use abrasive pad on areas with graphics.
• If a bristle brush is used to clean any of the cooking surfaces,
ensure no loose bristles remain on cooking surfaces prior
to cooking.
Grease build up can cause a fire. Clean any part of the
appliance that gets hot and experiences grease build up after
each use.
PLASTIC PARTS & PAINTED SURFACES:
Wash with warm soapy water and wipe dry with a non-abra-
sive cloth.
NOTICE
DO NOT use Citrisol, abrasive cleaners, or a concentrated
cleaner on plastic parts. This may result in damage to and
failure of parts.
Storing the Appliance goes here
FOR EVERY SURFACE
The Blackstone degreaser
and Cleaning Spray is gentle
enough to clean every surface
of your appliance. Use it on the
cooking surface, the appliance
frame, or anywhere that experi-
ences a build up of grease.
APPLIANCE STORAGE
DO NOT move the appliance when in use. Allow the appliance
to cool to 115°F (45°C) before moving or storing.
When not in use, turn oFF appliance by rotating the appliance
control knobs to the oFF position and closing the fuel valve.
When gas supply is connected to appliance, store appliance
outdoors in a cool, dry, well-ventilated space and out of reach of
children.
COVER FIT GUIDE
Always cover your appliance if stored outdoors.
Visit blackstoneproducts�com/support to find a
cover that will fit your appliance.
BLACKSTONEPRODUCTS.COM/SUPPORT
WARNING
WARNING
USING YOUR BLACKSTONE
CLEANING YOUR PIZZA STONE
NOTICE
DO NOT use soap on the cooking stone. This will leave a soap
taste in food.
Wash the cooking stone with warm water.
STEP 01
Rinse and dry completely.
STEP 02
CLEANING YOUR OVEN INTERIOR
Apply a strong solution of detergent and water, or use an oven
cleaner with scrub brush on insides of oven lid and bottom. Rinse
and allow to completely air dry.
dISCoNNeCT THe lPG CYlINdeR
only store the appliance indoors if the lPG cylinder is disconnected
and removed from the appliance.
ensure that the control knobs are turned to oFF.
STEP 01
once the appliance has cooled, disconnect the regulator
STEP 02
from the gas line by unscrewing the collar.
Unscrew the lPG cylinder from the regulator.
STEP 03
Place dust cap on lPG cylinder valve outlet whenever
STEP 04
cylinder is not in use.
only install the type of dust cap on cylinder valve outlet that is provided
with the cylinder valve� other types of caps or plugs may result in leakage
of propane�
| OWNER'S MANUAL
HO
Ov
m
ha
FOR
• Alw
• Ro
rea
FRE
STEP
STEP
size
requ
STEP
read
FRO
Follo
B
P
11
Publicidad
