RIDGID R9205 Manual Del Operador página 5

ASSEMBLY
R86116 HAMMER DRILL
UNPACKING
This product requires assembly.
 Carefully remove the tool and any accessories from the
box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled
to the product by the manufacturer and require
customer installation. Use of a product that may
have been improperly assembled could result in
serious personal injury.
 If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of
this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended
for use with this product. Any such alteration
or modification is misuse and could result in a
hazardous condition leading to possible serious
personal injury.
OPERATION
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always remove battery pack from the product when
you are assembling parts, making adjustments,
cleaning, or when not in use. Removing battery
pack will prevent accidental starting that could
cause serious personal injury.
Includes: Hammer drill, auxiliary handle assembly
INSTALLING/REMOVING THE AUXILIARY
HANDLE ASSEMBLY
See Figures 1 - 2, page 10.
An auxiliary handle is included for ease of operation and to
help prevent loss of control. The handle can be mounted for
left or right hand use.
To install the auxiliary handle assembly:
 Remove the battery pack.
 Turn the handle grip counterclockwise to loosen it and
open the hooks wide enough to fit over the mounting ribs,
behind the torque adjustment ring.
 Place the hooks over the mounting ribs, making sure the
hooks are positioned in the slots as shown.
NOTE: Make sure the notches on the inside of the auxiliary
handle engage the tabs on the drill housing.
 Turn the handle grip clockwise to tighten. Make sure the
handle assembly is secure before beginning operation.
To remove the handle assembly and install it on the
opposite side:
 Turn the handle grip counterclockwise to loosen and
remove the handle assembly.
 Reinstall the handle assembly in the desired position.
R86116 HAMMER DRILL/R86037 IMPACT DRIVER
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1, along with
hearing protection. Failure to do so could result in
objects being thrown into your eyes, resulting in
possible serious injury.
OVERLOAD PROTECTION
When the tool is forced or overloaded, the Li-ion battery pack
will automatically shut off the tool. To reset the tool, release
the trigger and resume operation. Do not force the tool.
HIGH TEMPERATURE PROTECTION
Li-ion battery packs are equipped with a high temperature
protection feature that automatically deactivates the tool
when it is overheated. To resume operation, allow the tool
to cool and then squeeze the trigger.
5 - English