Publicidad
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL THE INSTRUCTIONS
CAUTION: Do not plug power supply into outlet or turn power supply on if the
robot is not fully immersed in water.
Allow the cleaner to remain in the pool for 10-15min to the PVA brushes get
soft. Turn OFF the power supply, unplug it from the power outlet and take
the cleaner out of the pool when not in use. wash the brushes and the filters
with natural water and store it under the shade in room conditions. Always
remember to turn the power supply "OFF" and unplug it from the power outlet
before removing the cleaner from the pool.
WARNING: The cleaner must not be used when people are in
the pool. The pool cleaner should be used in residential pools
only
Safety Note
- The unit must be supplied through a residual current device (RCD)
having a rated residual operating current not exceeding 30 mA
- The connection to the branch circuit should be consistent with the
local and national wiring rules (electrical code).
- Mishandling of the unit can result in leakage of lubricants.
- If the supply cord is damaged, it must be replaced by a special
cord or assembly available from the manufacturer or its' Authorized
service center.
This appliance can be used by children aged from 8 years and above with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge if they have been given supervision or instruction concerning use
of the appliance in a safe way and understand the hazards involved. Children
shall not play with the appliance. Cleaning and user maintenance shall not be
made by children without supervision.
WARNING: A Ground Fault Current Interrupter (GFCI-USA) or a Residual
Current Device (RCD-EUROPE) must be installed to protect your electric outlet
and prevent any possible electric shock.
SAVE THESE INSTRUCTIONS
WR300 / WR400 ROBOTIC POOL CLEANERS
7/12
Publicidad
